DataCard SR200 User Manual page 61

Menu Display Settings
HR-T Temp
HR-B Temp
Speed
Cooling Time
HR Control
Count
Network
Printer Name
Host IF
Network>IPv4 DHCP
Setting:
SR200 & SR300 Printer and LM200 & LM300 Laminator User Guide
90 degC to 180 degC
90 degC to 180 degC
3.0 mm/s to 12.0 mm/s
0sec, 5sec, 7sec, 10sec,
15sec, 20sec, 30sec
Off
On
PRINTER01 to
PRINTER09
USB
LAN
ON
OFF
IP Address
Function
Displays the set point temperature of the top heat roller. (The
temperature may be 185 degC or higher depending on the
firmware version of the card printer.)
Displays the set point temperature of the bottom heat roller.
(The temperature may be 185 degC or higher depending on
the firmware version of the card printer.)
Displays the card speed during lamination.
Displays the standby time for cooling down the card before
lamination starts.
Displays whether the laminator will enter low temperature
standby mode. This setting works simultaneously with the
card printer setting. This is always set to 'On' automatically
when overlay film is selected. (Regardless of the setting, the
laminator should be put into standby if you will not be printing
cards for a long time.)
Displays the number of laminations performed after the last
roller cleaning. This number is reset to 0 each time a roller
cleaning is performed.
Assign the Network Name of the printer. Change this name
when more than one SR200 or SR300 printer is connected to
the network. Choose from the names supplied. If you set up a
network printer on the PC using a USB connection, this name
can be assigned from the PC.
View the connection method for the printer and PC, either
USB or LAN (Ethernet). The setting defaults to USB when the
printer is connected to a PC using a USB cable.
Dynamic Host Configuration Protocol (DHCP) is a network
feature that assigns IP addresses to devices on the network.
• ON uses DHCP to assign the printer IP address. The IP
Address can change when you power off the printer and
then power it on again.
• OFF means that you must assign the IP Address of the
printer and it will not change (Static IP). Use this setting if
your network does not support DHCP.
Ask your network administrator which setting to use.
The default IP address of the printer is 192.168.0.141, and is
displayed when the printer is powered on for the first time or
when DHCP is set to On.
If you do not use DHCP, ask your network administrator for
the IP Address to use.
55