DataCard SR200 User Manual page 60

Menu Display Settings
Option
MG None
Lo-Co
Hi-Co
IC Antenna None
Installed
IC Contact None
ISO Type
Contact IC None
R/W Installed
Bend None
Remedy HR Installed
Turn Over None
Installed
Laminator
Mode
Cassette
Film-T
Film-B
Film-T Pos
Film-B Pos
54
Laminate
Pass
None
Both
Bottom
Top
Patch
Overlay
Patch
Overlay
-7, -6, -5, -4, -3, -2, -1, 0,
1, 2, 3, 4, 5, 6, 7
-7, -6, -5, -4, -3, -2, -1, 0,
1, 2, 3, 4, 5, 6, 7
SR200 & SR300 Printer and LM200 & LM300 Laminator User Guide
Function
Displays the coercivity for writing data to ISO magnetic stripe
cards (if a magnetic stripe option is installed):
Lo-Co: 238 x 10 [A/m] (300[Oe])
2
Hi-Co: 218 x 10 [A/m] (2750[Oe])
3
Displays whether the contactless card option is installed:
• None for no antenna.
• Installed when a smart card antenna is used.
Displays whether the contact card option is installed:
• None for no contact.
• ISO type if a contact card option is installed.
Displays whether the contact card R/W option is installed:
• None for no contact.
• Installed when an internal contacts for external reader
option is installed.
Displays whether the bend remedy option is installed.
Displays whether the turn-over (duplex) option is installed.
Displays whether the laminator applies material to the card or
passes the card through the laminator.
Displays which cartridges are loaded.
Displays the type of film in the top cartridge.
Displays the type of film in the bottom cartridge.
Displays the patch position setting for the top cartridge.
Displays the patch position setting for the bottom cartridge.