DataCard SR200 User Manual page 52

Error Code Displayed Message
05000060 Thermostat is broken.
05000061 The temperature of the top side Heat
Roller is too high.
05000062 The temperature of the bottom side Heat
Roller is too high.
05000063 The internal temperature of the top side
Heater is too high.
05000064 The internal temperature of the bottom
side Heater is too high.
05000065 A hardware error has occurred in the top
side Heat Roller.
05000066 A hardware error has occurred in the
bottom side Heat Roller.
05000067 The thermistor of the top side Heat
Roller is faulty.
05000068 The thermistor of the bottom side Heat
Roller is faulty.
0500006B A cam error has occurred in the top side
Heat Roller.
0500006C A cam error has occurred in the bottom
side Heat Roller.
0500006D The operating ambient temperature of
the laminator is too low.
0500006E A hardware error has occurred in the top
side Film Supply Encoder.
0500006F A hardware error has occurred in the
bottom side Film Supply Encoder.
05000070 A hardware error has occurred in the top
side Film Take-up Encoder.
05000071 A hardware error has occurred in the
bottom side Film Take-up Encoder.
0500007D Other error is detected.
46
Solution
•
•
•
SR200 & SR300 Printer and LM200 & LM300 Laminator User Guide
Turn off the power and turn it on again. If the
same problem occurs, consult an authorized
dealer or service personnel.
User the laminator within the prescribed range.
When starting up the laminator in a low
temperature environment, the temperature of
the interior may remain low even though the
surrounding temperature has gone up. Turn on
the power again after waiting about one hour.
Turn off the power and turn it on again. If the
same problem occurs, consult an authorized
dealer or service personnel.