DataCard SR200 User Manual page 48

Error Code Displayed Message
0102FD00 The printer is in the Power Saving mode.
0102FE00 Password authentication is not
complete.
0102*** The printer is not ready.
01039000 Failure occurred during card loading.
01039100 Card jam near the card turn over unit.
01039200 Card jam near the magnetic encoder.
01039300 Card jam near the card feed roller.
01039400 Card jam near the card outlet.
01039500 Card jam near the retransfer heating
roller.
0103A100 Retransfer film is broken.
Retransfer film is not detected.
0103A800 A writing error has occurred during
magnetic encoder self-diagnosis.
42
Solution
Resetting the printer temporarily cancels the Power
Saving mode.
The printer resets automatically when the printer
driver is used to start printing.
—
—
1 Switch off the printer power.
2 See
3 Switch on the printer power.
1 Switch off the printer power.
2 See
3 Switch on the printer power.
1 Switch off the printer power.
2 See
3 Switch on the printer power.
1 Switch off the printer power.
2 See
3 Switch on the printer power.
1 Switch off the printer power.
2 See
3 Switch on the printer power.
1 Switch off the printer power.
2 See
3 Switch on the printer power.
1 Repair the ink ribbon as described in
2 Press Reset and then Enter to initialize the
Install the retransfer film correctly. See
retransfer film" on page 11
Check the card specifications.
SR200 & SR300 Printer and LM200 & LM300 Laminator User Guide
"Hopper jam" on page 72
card.
"Turnover jam" on page 74
card.
"Turnover jam" on page 74
card.
"Retransfer section jam" on page 75
remove the card.
"Retransfer section jam" on page 75
remove the card.
"Retransfer section jam" on page 75
remove the card.
broken ink ribbon or retransfer film" on
page 76
.
printer.
to remove the
to remove the
to remove the
to
to
to
"Mending
"Load
.