DataCard SR200 User Manual page 84

LCD Message
Jam (Retrans)
Film Search
Film Run Out
Ink Search
Ink Run Out
Ink Error
Please Adjust Turn Unit
Pos!
Cam Error
No Card
Door Open
Hardware
78
Possible Cause
There is a card jam near
the retransfer rollers.
The retransfer film is
broken or missing.
The retransfer film has run
out.
The ink ribbon is broken.
The ink ribbon has run out.
The ink ribbon is not
installed or the ribbon
installed is not supported.
The card turnover unit is
not in the correct position.
Heat roller operation error.
1 There are no cards in
the card hopper.
2 The card hopper has
been removed.
The printer door is open, or
a supply cartridge or
cleaning unit is missing.
There is a hardware error.
SR200 & SR300 Printer and LM200 & LM300 Laminator User Guide
Solution
1 Remove the jammed card from the retransfer
section.
2 Press Reset, and then Return to initialize the
printer.
"Retransfer section jam" on page 75
3 See
1 Repair the retransfer film as described in
broken ink ribbon or retransfer film" on page 76
2 Press Reset, Next, and then Return to initialize the
film one panel.
1 Replace with new roll of retransfer film as
"Load retransfer film" on page 11
described in
2 Initialize the new roll of film as described in
"Initialize the ink ribbon and retransfer film" on
page 17
.
1 Repair the ink ribbon as described in
broken ink ribbon or retransfer film" on page 76
2 Press Reset, Next, and then Return to initialize the
printer and supplies.
1 Replace with a new roll of ink ribbon as described
"Load ink ribbon" on page 10
in
2 Press Reset, Next, and then Return to initialize the
printer and supplies.
1 Install a supported ink ribbon.
2 Press Reset, Next, and then Return to initialize the
printer and supplies.
1 Turn the unit to the home position using a Jog Dial,
"Turnover jam" on page 74
as described in
2 Press Reset, and then Return to initialize the
printer. Call for service if the problem persists.
1 Press Reset, and then Return to initialize the
printer.
2 Call for service if the problem persists.
1 Load cards as described in
page 8
.
2 Replace the card hopper securely as described in
"Replace the Hopper" on page 9
1 Insert all supply cartridges and the cleaning unit.
2 Close the printer door.
3 Press Reset, and then Return to initialize the
printer.
Turn the power switch off and then on again. Call for
service if the problem persists.
.
"Mending
.
.
"Mending
.
.
.
"Load cards" on
.