DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Click the Apply button to accept the changes made.
Queue Settings
On this page, users can view and configure the queue settings. To view the following window, click QoS >
Basic Settings > Queue Settings, as shown below:
The fields that can be configured are described below:
Parameter
From Port ~ To Port
Queue ID
WRR Weight
WDRR Quantum
condition happens, the credits are replenished. When the credits are
replenished, a quantum of credits are added to each CoS queue credit
counter. The quantum for each CoS queue may be different based on
the user configuration.
To set a CoS queue in the SP mode, any higher priority CoS queue
must also be in the strict priority mode.
Enhanced Transmission Selection (ETS) provides bandwidth allocation
on converged links in end stations and bridges in a Data Center
Bridging (DCB) environment. Using bandwidth allocations, different
traffic classes within different traffic types such as LAN, SAN, IPC and
management can be configured to provide bandwidth allocation, low-
latency or best effort transmit characteristics.
Figure 7-3 Queue Settings Window
Description
Select the range of ports that will be used for this configuration here.
Enter the queue ID value here. This value must be between 0 and 7.
Enter the WRR weight value here. This value must be between 0 and
127. To satisfy the behavior requirements of Expedited Forwarding
(EF), the highest queue is always selected by the Per-hop Behavior
(PHB) EF and the schedule mode of this queue should be strict priority
scheduling. So the weight of the last queue should be zero while the
Differentiate Service is supported.
Enter the WDRR quantum value here. This value must be between 0
64