Mst Configuration Identification - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide

MST Configuration Identification

On this page, users can view and configure the MST configuration identification settings. These settings
will uniquely identify a multiple spanning tree instance set on the switch. The switch initially possesses
one CIST, or Common Internal Spanning Tree, of which the user may modify the parameters for but
cannot change the MSTI ID for, and cannot be deleted. To view the following window, click L2 Features >
Spanning Tree > MST Configuration Identification, as shown below:
The fields that can be configured for MST Configuration Settings are described below:
Parameter
Configuration Name
Revision Level
Click the Apply button to accept the changes made.
In the Private VLAN Synchronize section, the user can click the Apply button to synchronize the private
VLANs.
The fields that can be configured for Instance ID Settings are described below:
Parameter
Instance ID
Action
VID List
Click the Apply button to accept the changes made.
Click the Edit button to re-configure the specific entry.
Click the Delete button to remove the specific entry.
Figure 5-29 MST Configuration Identification Window
Description
Enter the MST. This name uniquely identifies the MSTI (Multiple
Spanning Tree Instance). If a Configuration Name is not set, this field
will show the MAC address to the device running MSTP.
Enter the revision level value here. This value must be between 0 and
65535. By default, this value is 0. This value, along with the
Configuration Name, identifies the MSTP region configured on the
switch.
Description
Enter the instance ID here. This value must be between 1 and 4094.
Select the action that will be taken here. Options to choose from are
Add VID and Remove VID.
Enter the VID list value here. This field is used to specify the VID range
from configured VLANs set on the switch.
45