Runco Video Xtreme VX-40d Owner's Operating Manual page 60

Section 3: Operation
To configure a "User" color adjustment (gamut), use either the Color Adjustment by
X/Y or Color Saturation submenu found in the Configuration menu under Geometry
and Color.
NOTES: 1) "Color Temperature" defaults to 6500K until changed. Both "User" options
default to SD Video unless they have been redefined by the user. 2) Factory defined
color primaries, which ensure consistent color gamut from projector-to-projector, can
be altered in the Service menu only. If you suspect alteration, the factory settings can be
recovered with selection of Factory Defaults in the Service menu (password-protected).
COLOR TEMPERATURE — Adjust to apply a specific and accurate color temperature
to all displays. Color temperatures are expressed in kelvins (3200-9300K), and utilize
different combinations of the projector's original native color primaries to produce
a "coloration" or cast (reddish or bluish) in images—the lower the temperature, the
more reddish the cast; the higher the temperature, the more bluish the cast. Note
that the slidebar is enabled only if you have a source connected and have selected
"Color Temperature" in the adjacent "Select Color Adjustment" pull-down list in the
Advanced Image Settings menu.
FRAME DELAY — Set the interval of delay desired between the input signal and
its appearance on screen. For applications such as simulation, where the feeling of
"real time" image response is a priority, a minimum setting is usually preferable. For
projectors capable of 3D (stereographic) applications where alternating left-right
frames must be synchronized with the corresponding L/R shutters in 3D glasses, a
frame delay setting of two (or multiple of two) may be more useful. Delay may vary
between sources.
MOTION FILTER — This control is most useful for smoothing out
moving images from interlaced sources. In most cases the proper
Motion Filter setting is automatically determined according to the type of
incoming source signal. However, if your source is jittery and/or tearing
you may wish to "force" a setting to ensure stable processing for this
source—if desired, override the default "Auto" setting by selecting the appropriate
motion filter:
1. AUTO: The projector will automatically use the correct motion filter according
to the incoming signal.
2. STILL: For static images with no motion, such as graphics from a CD.
3. MOTION: For video images that did not originate from film, or for moving
computer-generated images.
4. FILM: For video images that originated from film. This will optimize image
quality and stability.
FILM MODE THRESHOLD — This setting determines how sensitively the projector
can detect if an incoming video signal originated from film or not.
DETAIL THRESHOLD — Use "Detail Threshold" to define at what frequency level the
"Detail" control will begin to magnify high frequencies, which adds details back into
the image. Raise the threshold to ignore more of these high frequencies, and lower
the threshold to magnify more of these frequencies. A setting of "0", for example,
means no noise will be ignored and all will be magnified. An ideal detail threshold is
one in which high frequencies that are causing objectionable noise are not magnified
when using "Detail", but frequencies which can help sharpen an overly-soft image
are magnified when using "Detail".
52
Runco VX-40d/-50d/-60d/-80d Owner's Operating Manual