Connecting Communications - Runco Video Xtreme VX-40d Owner's Operating Manual

Section 2: Installation and Setup
2.4 Connecting
Communications
Remote Keypads
Serial Port Connections
As desired, direct the projector's IR remote keypad towards the projector's IR sensors.
➤
In normal operation, the DHD Controller will control the projector, but for setup and
calibration, use the projector remote.
There are two types of serial ports available on the projector: RS232 and RS422. The
➤
RS232 port is used for communication with the DHD Controller, and subsequently the
RS422 port will be unused. If the projector is used as a standalone unit, either port could
be used for serial control.
Connecting RS232 from the DHD Controller
The 9-pin DIN connector labeled RS232 IN on the input panel is dedicated to serial
communication with the DHD Controller. Using the appropriate serial communication
cables and supplied adapter, connect the DHD Controller.
From DHD Controller
Figure 2.13 Connecting RS232 from the Controller
Runco VX-40d/-50d/-60d/-80d Owner's Operating Manual
18