Operation; About The Projector - Runco Video Xtreme VX-40d Owner's Operating Manual

This section explains how to effectively operate the projector once it has been installed.
Runco recommends that you read this section and familiarize yourself with the components
and the available menu options before you begin using your projector.
Top IR Sensor
The built-in keypad is located at the back of the projector, beside the input panel. Use it
similarly to the IR remote to control the projector. A status LED display is also included on
this keypad for monitoring projector status.
The AC receptacle is located at the back of the projector just below the input panel. Use
this outlet to plug in an appropriately rated power cord. Refer to Section 6, Specifications,
for details.
Located on the underside of the projector are two fully adjustable feet. Raise or lower
these feet when positioning the projector to ensure it is level on all sides so the displayed
image will appear rectangular without any keystone. NOTE: The third foot, located at the
rear of the projector (underside) is not adjustable.
Refer to Adjusting Projector Height in Section 2 for instructions on how to adjust the
projector's feet.
Runco VX-40d/-50d/-60d/-80d Owner's Operating Manual
Front IR Sensor
Adjustable Feet (2)
Status LED Display
Built-in Keypad
Input Panel
Lamp Door
Non-adjustable Foot
Figure 3.1 Projector Basics
Projection Lens
AC Receptacle
21
SECTION 3

Operation

3.1 About the Projector

Built-in Keypad
AC Receptacle
Adjustable Feet