Runco Video Xtreme VX-40d Owner's Operating Manual page 46

Section 3: Operation
Editing a Channel Setup ➤
CHANNEL EDIT — STEP 1
CHANNEL EDIT — STEP 2
CHANNEL EDIT — STEP 3
TO DELETE MULTIPLE CHANNELS, highlight any channel in the Channel Setup menu
and press DIS (or FUNCN) to go to the Channel Copy/Delete submenu. Select "Delete
Unlocked Only" and press to delete all unlocked channels. Or select "Delete All Channels"
to delete all channels, even those that are locked. In either case, the current channel will
remain but will be redefined from projector defaults.
NOTE: For any deletion, a confirmation box appears to make sure that you really want to
delete. Select "Cancel" (default) if you don't want to delete after all.
The basic setups that describe how and where a channel can be accessed are listed in
the Channel Setup menu. These channel setups can be edited at any time in the Channel
Edit submenu.
From the presentation level press MENU to display the main menu. To display the Channel
Setup menu, press 3, or move the highlight to the Channel Setup option and press Enter
or ►. The Channel Setup menu will appear.
To edit parameters shown in the Channel Setup menu, select the relevant channel and
press Enter or ►. The Channel Edit menu, shown in Figure 3.12, appears.
If desired, review and/or edit the following channel setups in the Channel Edit menu:
• CHANNEL NAME: An alpha-numeric label can be defined and/or changed here.
Channel names can be up to 12 characters in length.
• CHANNEL NUMBER: A 2-digit channel number can be changed here.
NOTES: 1) If you enter a channel number that already exists, a dialog message
appears indicating that this number is already in use – assign a different channel
number. 2) You can define up to 50 channels.
• INPUT: 1-8, corresponding to where on the projector's input panel the source is
connected.
• IN MENU: If checked (default, except for automatically defined channels with
unchanged parameters), this defined channel will then appear in the list available
when CHANL key is pressed. If unchecked, the channel must be accessed via
CHANL on the keypad or via the Auto Source function.
NOTE: To enable or disable on-screen display of the Channel List, use the Menu
Preferences menu (described later in this section).
38
Figure 3.12. Typical Channel Edit Menu
Runco VX-40d/-50d/-60d/-80d Owner's Operating Manual