Displaying The Cycle Time - Omron SRM1(-V2) Operation Manual

Programming Console Operations

4-2-28 Displaying the Cycle Time

1, 2, 3...
58
This operation is used to display the current average cycle time (scan time).
It is possible only in RUN or MONITOR mode while the program is being exe-
cuted.
RUN
OK OK
1. Press the CLR Key to bring up the initial display.
2. Press the MONTR Key to display the cycle time.
MONTR
There might be differences in displayed values when the MONTR Key is
pressed repeatedly. These differences are caused by changing execution
conditions.
MONITOR PROGRAM
No
00000SCAN TIME
012.1MS
"MS" in the display indicates
the unit "ms" for the cycle time.
Section 4-2