Unsigned Decimal Data Modification; Force Set, Reset - Omron SRM1(-V2) Operation Manual

Programming Console Operations

4-2-24 Unsigned Decimal Data Modification

! Caution
1, 2, 3...

4-2-25 Force Set, Reset

! Caution
1, 2, 3...
56
This operation is used to change the decimal value of a word being moni-
tored as unsigned decimal data. A change into hexadecimal data is made
automatically.
Words SR 253 to SR 255 cannot be changed.
RUN
No OK
Before changing the contents of I/O memory, be sure that the changes will not
cause equipment to operate unexpectedly or dangerously. In particular, take
care when changing the status of output bits. The PC continues to refresh I/O
bits even if the PC is in PROGRAM mode, so devices connected to output points
may operate unexpectedly.
1. Monitor (unsigned decimal) the status of the word for which the present val-
ue is to be changed.
(Unsigned decimal monitor)
2. Press the CHG Key to begin decimal data modification.
3. Input the new PV and press the WRITE Key to change the PV. The operation
will end and the decimal-without-sign monitoring display will return when the
WRITE Key is pressed.
The PV can be set within a range of 0 to 65,535.
D C
3 2 7 6
Press the CLR Key or the SHIFT and TR Keys to return to the normal moni-
toring display.
If an erroneous input has been made, press the CLR Key to restore the sta-
tus prior to the input. Then enter the correct input.
This operation is used to force bits ON (force set) or OFF (force reset) and is
useful when debugging the program or checking output wiring. It is possible
in MONITOR or PROGRAM mode only.
RUN
No OK
Before changing the contents of I/O memory, be sure that the changes will not
cause equipment to operate unexpectedly or dangerously. In particular, take
care when changing the status of output bits. The PC continues to refresh I/O
bits even if the PC is in PROGRAM mode, so devices connected to output points
may operate unexpectedly.
1. Monitor the status of the desired bit according to the procedure described in
4-2-13 Bit, Digit, Word Monitor. If two or more words are being monitored,
the desired bit should be leftmost on the display.
(Multiple address monitor)
MONITOR PROGRAM
OK
c200
65520
PRES VAL?
CHG
c200 65520
c200
8 WRITE
32768
MONITOR PROGRAM
OK
0000020000
^ OFF^ ON
Section 4-2