Procedures From System Design To Test Operation - Omron SRM1(-V2) Operation Manual

Procedures From System Design to Test Operation

Host Computers, PTs, and
PCs
1-3 Procedures From System Design to Test Operation
1, 2, 3...
• Instructions will be displayed that are not supported by the SRM1. Do not use
these instructions.
CX-Programmer and SYSMAC-CPT
The following instructions cannot be programmed when using the CX-Program-
mer or SYSMAC-CPT. Errors will occur if an attempt is made to transfer them
from the PC to the computer: SCL(66)/@SCL(66), ZCP, NEG/@NEG, and PID.
An SRM1(-V2) can be connected an IBM PC/AT or compatible computer or OM-
RON PT through an RS-232C Adapter (CPM1-CIF01) mounted to the SRM1's
peripheral port. (Use Host Link mode when connecting a PT through an
RS-232C Adapter.)
The RS-232C port on an SRM1-C02-V2 can be used to connect directly to an
IBM PC/AT or compatible computer, OMRON PT, or PC (C200HX/HG/HE,
C200HS, CQM1, CPM1, CPM1A, CPM2A, or CPM2C). (Use Host Link mode or
NT Link mode when connecting a PT directly.)
The procedures from system design to test operation are explained in the sec-
tions of this manual as follows and in the CPM1/CPM1A/CPM2A/CPM2C/
SRM1(-V2) Programming Manual (W353):
1. System Design
Refer to 3-1 System Design.
2. Installation
Refer to 3-3 Installing the SRM1.
3. Wiring
Refer to 3-4 Wiring and Connections.
4. Creating the Ladder Program
Refer to the relevant sections in the CPM1/CPM1A/CPM2A/CPM2C/
SRM1(-V2) Programming Manual (W353) and the applicable PC manual.
5. Inputting the Program
Refer to Section 4 Using the Programming Console, Section 5 Test Runs
and Error Processing, CX-Programmer Users Manual (W346), SYSMAC
Support Software (SSS) Operation Manuals (W247 and W248), and SYS-
MAC-CPT Support Software Quick Start Guide (W332) and User Manual
(W333).
6. Test Operation
Refer to 5-1-2 SRM1 Test Run Procedure.
Section 1-3
7