Buzzer Operation - Omron SRM1(-V2) Operation Manual

Programming Console Operations
Key Sequence
1, 2, 3...
Caution
!

4-2-4 Buzzer Operation

Key Sequence
1, 2, 3...
Follow the procedure below to display and clear messages.
1. Press the CLR Key to bring up the initial display.
2. Press the FUN and then the MONTR Key to begin the operation. If there are
no messages, the following display will appear:
FUN MONTR
If there are messages, the most serious message will be displayed when the
MONTR Key is pressed. Pressing MONTR again will clear the present mes-
sage and display the next most serious error message. Continue pressing
MONTR until all messages have been cleared. These are some examples
of error messages:
A memory error:
MONTR
A system error:
MONTR
A message:
MONTR
All messages cleared:
MONTR
Check to be sure that no equipment is affected when turning the SRM1's power
supply on or off, or when entering the password. Be careful not to cause any ac-
cidents when starting or stopping SRM1 operation.
This operation is used to turn on and off the buzzer that sounds when Program-
ming Console keys are pressed. This buzzer will also sound whenever an error
occurs during PC operation. Buzzer operation for errors is not affected by this
setting.
This operation is possible in any mode.
RUN
OK OK
Follow the procedure below to turn the key-input buzzer on and off.
1. Press the CLR, SHIFT, and then the CLR Key to bring up the mode display.
In this case the PC is in PROGRAM mode and the buzzer is on.
2. Press the SHIFT and then the 1 Key to turn off the buzzer.
ERR/MSG CHK OK
MEMORY ERR
SYS FAIL FAL01
MATERIAL USED UP
ERR/MSG CHK OK
MONITOR PROGRAM
OK
<MONITOR>
Section 4-2
BZ
39