Additional Camera Connection - Lorex SG6333 Instruction Manual

OPERATION
Camera
(1) Connect the power adapter to the camera power input and ensure the camera is
set to channel 1. You can turn the camera ON/OFF by holding the Channel
button for 3 seconds. An LED light will appear illuminated when the camera is
set to "ON".
Monitor
(1) Connect the supplied power adaptor to the power input of the monitor. Make
sure the adapter connected to the monitor is labeled monitor.
(2) Use the channel selection switch button and ensure the monitor is set to the
same channel as the camera to view the picture.
Note: If you experience transmission reception problems (eg. poor picture), you may need
to select another channel on the camera and monitor and/or adjust the antenna on the
monitor.
(3) Adjust the volume to the desired level. You may also mute the audio option by
pressing the mute button which is located at the front of the monitor.
(4) Adjust the brightness and contrast level as required
Note: Try to position both the Camera and Monitor as high off the ground as possible for
better picture reception

ADDITIONAL CAMERA CONNECTION

This video security system allows you to view up to four different camera locations.
Additional cameras are sold separately. For more information, please refer to:
www.lorexcctv.com
When connecting more than one camera to the monitor/camera system, you will need
to set each camera to a different channel (Channels 1-4).
CH 1
CH 3
7
CH 2
CH 4