Camera Installation - Lorex LW1000P Series Instruction Manual

Camera Installation

Before you install the camera(s), carefully plan where and how it will be positioned, and where you will
route the cable that connects the camera to the power adaptor or battery adaptor.
Installation Warnings:
Aim the Cameras to best optimize the viewing area: Select a location for the camera that provides
a clear view of the area you want to monitor, which is free from dust, and is not in line-of-sight to
a strong light source or direct sunlight.
Avoid installing the cameras where there are thick walls, obstructions, or interference (i.e.
cement, concrete, metal, transformers, or other electrical equipment) between the Cameras and
the Receiver. This will reduce the transmission range.
Select a location for the camera that has an ambient temperature between 14°F~113°F
(-10°C~45°C)
Before starting permanent installation, have another person hold the camera for you while you
verify its performance by observing the image on a monitor.
Audio feedback may occur when the receiver and camera(s) are too close (under 10 feet /3
meters.
Night Vision
This camera includes IR LEDs, which provide the camera with the ability to view images in low light
conditions. It is important to use the provided power adaptor (not the 9V DC Battery Adaptor) when using
the camera for prolonged periods in low light conditions, as the LEDs will drain the battery more quickly
than regular daytime use.
Installing the Camera:
1. Carefully unpack the Camera.
2. Decide whether the camera will be permanently wall mounted or sit on a
tabletop:
If you decide to place the camera on a tabletop or other flat surface,
the camera can easily be moved to different locations as desired. It is
strongly recommended that the camera be affixed to the table top
surface to prevent damage to the camera in case of tabletop surface
movement or improper handling.
If you decide to permanently mount the camera to a wall, make sure to
select a location close to a power outlet.
NOTE: Wireless cameras require a power source (either an electrical
outlet or battery power) to operate. If you plan to permanently mount the camera in a location, it is
recommended to use the included Camera Power adaptor to prevent interruptions in the image, as
the battery adaptor is intended as a temporary power solution.
NOTE: The LW1010P, LW1012P, LW1020P, and LW1022P are expandable.
To order additional cameras please call 00-800-425-6739-0, option 1,1
10
Camera Installation
Table Top Mount:
The Camera can be
placed on any flat
surface.