Accessory Tray - Life Fitness Lifecycle 9500HR Series Service Manual

Lifecycle 9500HR / 9100 Series Recumbent Exercise Bikes
How To... REPLACE THE ACCESSORY TRAY
Tools Required: Phillips screwdriver and 5/32" Hex Key wrench
Recumbent Models
9500HR
9100, 5500HR, 4500
1. Using a Hex Key wrench remove the four SCREWS (A) and WASHERS (B) securing the SEAT BACK (C).
Remove the SEAT BACK and set it aside.
2. Slide the ACCESSORY TRAY (D) over the user right SEAT BACK POST (E) and down to make contact with the
SEAT HANDLEBAR (F).
3. Position the UNDERSIDE CLAMP BRACKET (G) around the SEAT HANDLEBAR (F) and tighten the two
CLAMP SCREWS and WASHERS (H).
NOTE: BE CAREFUL NOT TO OVER-TIGHTEN
THE SCREWS (H).
4. Align the four holes in the SEAT BACK (B) with
those in the SEAT BACK POSTS. Insert the four
SCREWS (A) and WASHERS (B) through the
backside of the SEAT BACK POSTS (E) and into
the SEAT BACK. Tighten the four SCREWS
securely.
NOTE: BE CAREFUL NOT TO OVER-TIGHTEN THE
SCREWS (A).
Kit Required
AK51-00072-0000
AK51-00074-0000
D
E
B
A
C
F
G
H
31