Life Fitness Lifecycle 9500HR Series Service Manual page 65

Lifecycle 9500HR / 9100 Series Recumbent Exercise Bikes
How To... REPLACE THE DIGITAL HEART RATE SENSORS (continued)
Installing the new Lifepulse digital heart rate sensors:
4. Plug the Faston connector (red or white wire) to the back of the new, pre-assembled signal output sensor
assembly (this will be the assembly without the screw access holes in the sensor) and locate it into position.
This sensor will be the sensor on which the palm rests during use.
5. Plug the Faston connector (black or green wire) to the back of the new, pre-assembled ground sensor
assembly (this will be the assembly with the screw access holes in the sensor) and locate it into position. This is
the sensor on which the fingertips rest during use.
6. Install the two screws through the access holes in the ground sensor and torque to 5 - 7 in. Lb. .
7. Repeat Steps 1 through 6 to remove and replace the second set of sensors included in the kit.
22