Lifecycle 9500HR / 9100 Series Recumbent Exercise Bikes
How To... REPLACE THE STABILIZER BAR
Tools Required: 1/2 inch wrench, short length of 2x4 board or a small box of same size to support bike
1. Raise the rear of the bike and support it with a piece of
2x4 board under the rear of the bike and in front of the
STABILIZER BAR.
2. Remove the two STABILIZER BOLTS from the bottom of
the STABILIZER BAR. Remove the STABILIZER BAR
from the bike frame.
3. Install the new STABILIZER BAR and tighten the bolts to
a torque of 200 to 220 INCH LBS. Make sure the
STABILIZER BAR is mounted flush against the rear
frame of the bike.
4. If the bike is not level, turn the two LEVELERS as
necessary to eliminate all rocking motion.
Stabilizer Bar
Stabilizer Bolts
Torque 200-220 IN. LBS.
27