Hard disk and solid state drives
6.2.4
Removing the HDD/SSD module
Ê Pull the HDD/SSD module out a few centimeters.
Ê Wait for at least 60 seconds.
I
This period is necessary for the RAID controller to recognize that an
HDD/SSD module has been removed and for the hard disk drive to
come to a stop.
Ê Pull the HDD/SSD module out completely.
6.2.5
Completing the task
Perform one of the following procedures to complete the task:
1.
"Installing the dummy module" on page 88
2.
"Installing the HDD/SSD module" on page 80
6.3
Removing the HDD/SSD module
Trained personnel
6.3.1
Required tools
Starting and completing the task:
– key for the rack doors (if applicable)
Removing the HDD/SSD module: tool-less
6.3.2
Starting the task
Ê Perform the following procedures:
1.
"Opening the rack door" on page 40
86
Upgrade and Maintenance Manual
RX900 S2