Basic procedures
4.4
Sliding the server out of the rack
Trained personnel
V
CAUTION!
Use the anti-tilt plate to prevent the rack from tipping when installing
the rack. Pulling the server out of the rack without having installed the
anti-tilt plate may cause the rack to tip over.
Be careful not to pinch fingers or clothes when sliding out the server
or pushing it back. Failure to do so may cause injury.
Follow the safety instructions in the
page
31.
Figure 4: Removing the server
Ê Loosen the knurled screws (see circle).
42
Upgrade and Maintenance Manual
chapter "Safety instructions" on
RX900 S2