Removing The Sas Backplane; Installing The Sas Backplane - Fujitsu PRIMERGY RX900 S2 Upgrade And Maintenance Manual

Hide thumbs Also See for PRIMERGY RX900 S2:

Table of Contents

Hard disk and solid state drives

Removing the SAS backplane

Figure 43: Removing the SAS backplane

Ê Loosen the captive screw (see circle) on the SAS backplane.

Ê Remove the SAS backplane by pulling it straight upward. Do not tilt it.

Figure 44: Installing the SAS backplane

Ê Insert the SAS backplane into the bay until it clicks into place. Do not tilt it.

Make sure that the SAS backplane is installed correctly. Otherwise

the HDD/SSD modules can be damaged when you install them.

Ê Fasten the captive screw (see circle) on the SAS backplane.

Upgrade and Maintenance Manual