Interface; Chapter 10 Interface; Interface Overview; What You Can Do In The Interface Screens - ZyXEL Communications ZyWALL USG 100 Series User Manual

C
H A P T E R

10.1 Interface Overview

Use the Interface screens to configure the ZyWALL's interfaces. You can also create
interfaces on top of other interfaces.
• Ports are the physical ports to which you connect cables.
• Interfaces are used within the system operationally. You use them in configuring various
features. An interface also describes a network that is directly connected to the ZyWALL.
For example, You connect the LAN1 network to the LAN1 interface.
• Zones are groups of interfaces used to ease security policy configuration.

10.1.1 What You Can Do in the Interface Screens

• Use the Status screen
and their packet statistics.
• Use the Port Role screens
as lan1, ext-wlan or dmz.
• Use the Ethernet screens
Ethernet interfaces are the foundation for defining other interfaces and network policies.
RIP and OSPF are also configured in these interfaces.
• Use the PPP screens
• Use the Cellular screens
for Internet connections through an installed 3G card.
• Use the WLAN screens
a wireless LAN card.
• Use the VLAN screens
multiple logical networks. VLAN interfaces receive and send tagged frames. The
ZyWALL automatically adds or removes the tags as needed. Each VLAN can only be
associated with one Ethernet interface.
• Use the Bridge screens
segments into a single network.
• Use the Auxiliary screens
auxiliary interface to use an external modem.
• Use the Virtual Interface screen
on top of Ethernet interfaces to tell the ZyWALL where to route packets. You can create
virtual Ethernet interfaces, virtual VLAN interfaces, and virtual bridge interfaces.
• Use the Trunks screens
ZyWALL USG 100/200 Series User's Guide
(Section 10.2 on page 206) to see all of the ZyWALL's interfaces
(Section 10.3 on page
(Section 10.4 on page
(Section 10.6 on page 225) for PPPoE or PPTP Internet connections.
(Section 10.7 on page
(Section 10.9 on page 237) to configure settings for interfaces on
(Section 10.12 on page 251) to divide the physical network into
(Section 10.13 on page 259) to combine two or more network
(Section 10.14 on page
(Section 10.15 on page
(Chapter 11 on page 273) to configure load balancing.
10

Interface

209) to set the ZyWALL's flexible ports
210) to configure the Ethernet interfaces.
230) to configure settings for interfaces
266) to configure the ZyWALL's
267) to create virtual interfaces
203