Interface; Trunks - ZyXEL Communications ZyWALL USG 100 Series User Manual

WHERE USED
Example: This provides a simple example to show you how to configure this feature. The
example is usually based on the network topology in
PREQUISITES or WHERE USED does not appear if there are no
prerequisites or references in other features to this one. For example, no other
features reference DDNS entries, so there is no WHERE USED entry.

5.4.2 Interface

See Section 5.2 on page 112
When you create an interface, there is no security applied on it until you assign
it to a zone.
Most of the features that use interfaces support Ethernet, PPPoE/PPTP, cellular, wireless LAN,
VLAN, and bridge interfaces.
MENU ITEM(S)
PREREQUISITES
WHERE USED
Example: The dmz interface is in the DMZ zone and uses a private IP address. To configure
dmz's settings, click Network > Interface > Ethernet and then the dmz's Edit icon.

5.4.3 Trunks

Use trunks to set up load balancing using two or more interfaces.
MENU ITEM(S)
PREREQUISITES
WHERE USED
Example: See
ZyWALL USG 100/200 Series User's Guide
There are two uses for this.
These are other features you should usually configure or check right after you
configure the main screen(s) for this feature. For example, you should usually
create a policy route for a VPN tunnel.
You have to delete the references to this feature before you can delete any
settings. For example, you have to delete (or modify) all the policy routes that
refer to a VPN tunnel before you can delete the VPN tunnel.
for background information.
Network > Interface (except Network > Interface > Trunk)
Port groups (configured in the Interface > Port Roles screen)
Zones, trunks, IPSec VPN, device HA, DDNS, policy routes, static routes, HTTP
redirect, virtual server, application patrol
Network > Interface > Trunk
Interfaces
Policy routes
Chapter 6 on page 129.
Chapter 5 Configuration Basics
Figure 46 on page 114.
117