ZyXEL Communications ZyWALL USG 100 Series User Manual page 234

Chapter 10 Interface
Table 63 Interface > Cellular > Add (continued)
LABEL
PIN Code
Interface
Parameters
Egress
Bandwidth
Ingress
Bandwidth
MTU
Connectivity
Check
Enable
Connectivity
Check
Check Method
Check Period
Check Timeout Enter the number of seconds to wait for a response before the attempt is a failure.
Check Fail
Tolerance
Check Default
Gateway
Check this
address
Check Port
Related Setting
Add this
interface to
TRUNK to
allow WAN
load balance.
Policy Route
234
DESCRIPTION
This field displays with a GSM or HSDPA 3G card. A PIN (Personal Identification
Number) code is a key to a 3G card. Without the PIN code, you cannot use the 3G
card.
Enter the 4-digit PIN code (0000 for example) provided by your ISP. If you enter
the PIN code incorrectly, the 3G card may be blocked by your ISP and you cannot
use the account to access the Internet.
If your ISP disabled PIN code authentication, enter an arbitrary number.
Click Advanced to display more settings. Click Basic to display fewer settings.
Enter the maximum amount of traffic, in kilobits per second, the ZyWALL can send
through the interface to the network. Allowed values are 0 - 1048576. This setting
is used in WAN load balancing and bandwidth management.
This is reserved for future use.
Enter the maximum amount of traffic, in kilobits per second, the ZyWALL can
receive from the network through the interface. Allowed values are 0 - 1048576.
Maximum Transmission Unit. Type the maximum size of each data packet, in
bytes, that can move through this interface. If a larger packet arrives, the ZyWALL
divides it into smaller fragments. Allowed values are 576 - 1492. Usually, this
value is 1492.
The interface can regularly check the connection to the gateway you specified to
make sure it is still available. You specify how often the interface checks the
connection, how long to wait for a response before the attempt is a failure, and
how many consecutive failures are required before the ZyWALL stops routing to
the gateway. The ZyWALL resumes routing to the gateway the first time the
gateway passes the connectivity check.
Select this to turn on the connection check.
Select the method that the gateway allows.
Select icmp to have the ZyWALL regularly ping the gateway you specify to make
sure it is still available.
Select tcp to have the ZyWALL regularly perform a TCP handshake with the
gateway you specify to make sure it is still available.
Enter the number of seconds between connection check attempts.
Enter the number of consecutive failures before the ZyWALL stops routing
through the gateway.
Select this to use the default gateway for the connectivity check.
Select this to specify a domain name or IP address for the connectivity check.
Enter that domain name or IP address in the field next to it.
This field only displays when you set the Check Method to tcp. Specify the port
number to use for a TCP connectivity check.
Select this option to use the interface as part of a WAN trunk for load balancing.
Click this link to go to the screen where you can manually configure a policy route
to associate traffic with this interface.
ZyWALL USG 100/200 Series User's Guide