Configuring Sp+Wrr Queues - 3Com Switch 4800G 24-Port Configuration Manual

Configuration Examples
Configuring SP+WRR
Queues
Configuration Procedure
Network requirements
Configure WRR queue scheduling algorithm on GigabitEthernet1/0/1, and assign
weight 1, 2, 4, 6, 8, 10, 12, and 14 to queue 0 through queue 7.
Configuration procedure
# Enter system view.
<Sysname> system-view
# Configure the WRR queues on GigabitEthernet1/0/1 port.
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] qos wrr 0 group 1 weight 1
[Sysname-GigabitEthernet1/0/1] qos wrr 1 group 1 weight 2
[Sysname-GigabitEthernet1/0/1] qos wrr 2 group 1 weight 4
[Sysname-GigabitEthernet1/0/1] qos wrr 3 group 1 weight 6
[Sysname-GigabitEthernet1/0/1] qos wrr 4 group 1 weight 8
[Sysname-GigabitEthernet1/0/1] qos wrr 5 group 1 weight 10
[Sysname-GigabitEthernet1/0/1] qos wrr 6 group 1 weight 12
[Sysname-GigabitEthernet1/0/1] qos wrr 7 group 1 weight 14
As required, you can configure part of the queues on the port to adopt the SP
queue-scheduling algorithm and parts of queues to adopt the WRR
queue-scheduling algorithm. Through adding the queues on a port to the SP
scheduling group and WRR scheduling group (namely, group 1), the SP+WRR
queue scheduling is implemented. During the queue scheduling process, the
queues in the SP scheduling group is scheduled preferentially. When no packet is
to be sent in the queues in the SP scheduling group, the queues in the WRR
scheduling group are scheduled. The queues in the SP scheduling group are
scheduled according to the strict priority of each queue, while the queues in the
WRR queue scheduling group are scheduled according the weight value of each
queue.
Follow these steps to configure SP + WRR queues:
To do...
Enter system view
Enter port Enter port
view or view
port group
Enter port
view
group view
Configure SP queue
scheduling
Use the command...
system-view
interface interface-type
interface-number
port-group { manual
port-group-name |
aggregation agg-id }
qos wrr queue-id group sp

Configuring SP+WRR Queues

Remarks
-
Perform either of the two
operations.
The configuration performed in
Ethernet port view applies to
the current port only. The
configuration performed in
port group view applies to all
the ports in the port group.
Required
By default, all the ports adopt
the WRR queue scheduling
algorithm, with the weight
values assigned to queue 0
through queue 7 being 1, 2, 3,
4, 5, 9, 13, and 15.
881