3Com Switch 4800G 24-Port Configuration Manual page 710

710 C 49: M
HAPTER ULTICAST
R F C
OUTING AND ORWARDING
Switch A, Switch B and Switch C run OSPF.
■
Typically, Receiver can receive the multicast data from Source through the path
■
Switch A - Switch B, which is the same as the unicast route.
Perform the following configuration so that Receiver can receive the multicast
■
data from Source through the path Switch A - Switch C - Switch B, which is
different from the unicast route.
Network diagram
Figure 208 Network diagram for RPF route alternation configuration
Vlan -int103
40.1.1 .2/24
Switch A
Vlan -int200
50.1.1.1 /24
Multicast static route
Configuration procedure
1 Configure the interface IP addresses and enable unicast routing on each switch
Configure the IP address and subnet mask for each interface as per Figure 208.
The detailed configuration steps are omitted here.
Enable OSPF on the switches in the PIM-DM domain. Ensure the network-layer
interoperation among the switches in the PIM-DM domain. Ensure that the
switches can dynamically update their routing information by leveraging the
unicast routing protocol. The specific configuration steps are omitted here.
2 Enable IP multicast routing, and enable PIM-DM and IGMP
# Enable IP multicast routing on Switch B, enable PIM-DM on each interface, and
enable IGMP on the host-side interface Ethernet 1/0.
<SwitchB> system-view
[SwitchB] multicast routing-enable
[SwitchB] interface vlan-interface 100
[SwitchB-Vlan-interface100] igmp enable
[SwitchB-Vlan-interface100] pim dm
[SwitchB-Vlan-interface100] quit
[SwitchB] interface vlan-interface 101
[SwitchB-Vlan-interface101] pim dm
ONFIGURATION
Switch C
Vlan -int103 Vlan -int101
40 .1 .1.1/24 20 .1 .1.2/24
PIM-DM
Vlan -int102
30.1.1.2/24
Source
50 .1.1.100/24
Vlan -int101
20 .1.1.1/24
Switch B
Vlan -int102
30.1.1.1/24
Vlan -int100
10.1.1.1/24
Receiver
10.1.1.100 /24