3Com Switch 4800G 24-Port Configuration Manual page 39

Console Port Login Configuration with Authentication Mode Being Password
To do...
Configure Set the
the console baud rate
port
Set the
check
mode
Set the
stop bits
Set the
data bits
Configure the command
level available to users
logging in to the user
interface
Define a shortcut key for
starting terminal sessions
Define a shortcut key for
aborting tasks
Make terminal services
available to the user
interface
Set the maximum
number of lines the
screen can contain
Set history command
buffer size
Set the timeout time for
the user interface
Note that if you configure to authenticate the users in the password mode, the
command level available to users logging in to a switch depends on both the
Use the command...
speed speed-value
parity { even | mark |
none | odd | space }
stopbits { 1 | 1.5 | 2 }
databits { 5 | 6 | 7 | 8 }
user privilege level level
activation-key character
escape-key { default |
character }
shell
screen-length
screen-length
history-command
max-size value
idle-timeout minutes
[ seconds ]
Remarks
Optional
The default baud rate of an AUX port
(also the console port) is 9,600 bps.
Optional
By default, the check mode of a
console port is set to none, that is, no
check bit.
Optional
The default stop bits of a console port
is 1.
Optional
The default data bits of a console port
is 8.
Optional
By default, commands of level 3 are
available to users logging in to the
AUX user interface.
Optional
By default, pressing Enter key starts
the terminal session.
Optional
The default shortcut key combination
for aborting tasks is < Ctrl+C >.
Optional
By default, terminal services are
available in all user interfaces.
Optional
By default, the screen can contain up
to 24 lines.
You can use the screen-length 0
command to disable the function to
display information in pages.
Optional
The default history command buffer
size is 10. That is, a history command
buffer can store up to 10 commands
by default.
Optional
The default timeout time of a user
interface is 10 minutes.
With the timeout time being 10
minutes, the connection to a user
interface is terminated if no operation
is performed in the user interface
within 10 minutes.
You can use the idle-timeout 0
command to disable the timeout
function.
39