3Com Switch 4800G 24-Port Configuration Manual page 711

Creating an RPF Route
[SwitchB-Vlan-interface101] quit
[SwitchB] interface vlan-interface 102
[SwitchB-Vlan-interface102] pim dm
[SwitchB-Vlan-interface102] quit
# Enable IP multicast routing on Switch A, and enable PIM-DM on each interface.
<SwitchA> system-view
[SwitchA] multicast routing-enable
[SwitchA] interface vlan-interface 200
[SwitchA-Vlan-interface200] pim dm
[SwitchA-Vlan-interface200] quit
[SwitchA] interface vlan-interface 102
[SwitchA-Vlan-interface102] pim dm
[SwitchA-Vlan-interface102] quit
[SwitchA] interface vlan-interface 103
[SwitchA-Vlan-interface103] pim dm
[SwitchA-Vlan-interface103] quit
The configuration on Switch C is similar to the configuration on Switch A. The
specific configuration steps are omitted here.
# Use the display multicast rpf-info command to view the RPF route to Source
on Switch B.
[SwitchB] display multicast rpf-info 50.1.1.100
RPF information about source 50.1.1.100:
RPF interface: Vlan-interface102, RPF neighbor: 30.1.1.2
Referenced route/mask: 50.1.1.0/24
Referenced route type: igp
Route selection rule: preference-preferred
Load splitting rule: disable
As shown above, the current RPF route on Switch B is contributed by a unicast
routing protocol and the RPF neighbor is Switch A.
3 Configure a multicast static route
# Configure a multicast static route on Switch B, specifying Switch C as its RPF
neighbor on the route to Source.
[SwitchB] ip rpf-route-static 50.1.1.100 24 20.1.1.2
4 Verify the configuration
# Use the display multicast rpf-info command to view the information about
the RPF route to Source on Switch B.
[SwitchB] display multicast rpf-info 50.1.1.100
RPF information about source 50.1.1.100:
RPF interface: Vlan-interface101, RPF neighbor: 20.1.1.2
Referenced route/mask: 50.1.1.0/24
Referenced route type: multicast static
Route selection rule: preference-preferred
Load splitting rule: disable
As shown above, the RPF route on Switch B has changed. It is now the configured
multicast static route, and the RPF neighbor is now Switch C.
Network requirements
PIM-DM runs in the network and all switches in the network support IP
■
multicast.
Configuration Examples 711