3Com Switch 4800G 24-Port Configuration Manual page 116

116 C 11: GVRP C
HAPTER
GVRP Configuration
Example II
ONFIGURATION
Network requirements
Configure GVRP for dynamic VLAN information registration and update among
devices. Specify fixed GVRP registration on Device A and normal GVRP registration
on Device B.
Network diagram
Figure 33 Network diagram for GVRP configuration
GE1/0/1
Device A
Configuration procedure
1 Configure Device A
# Enable GVRP globally.
<DeviceA> system-view
[DeviceA] gvrp
# Configure port GigabitEthernet 1/0/1 as a Trunk port, allowing all VLANs to pass.
[DeviceA] interface GigabitEthernet 1/0/1
[DeviceA-GigabitEthernet1/0/1] port link-type trunk
[DeviceA-GigabitEthernet1/0/1] port trunk permit vlan all
# Enable GVRP on GigabitEthernet 1/0/1.
[DeviceA-GigabitEthernet1/0/1] gvrp
# Set the GVRP registration type to fixed on the port.
[DeviceA-GigabitEthernet1/0/1] gvrp registration fixed
[DeviceA-GigabitEthernet1/0/1] quit
# Create VLAN 2 (a static VLAN).
[DeviceA] vlan 2
2 Configure Device B
# Enable GVRP globally.
<DeviceB> system-view
[DeviceB] gvrp
# Configure port GigabitEthernet 1/0/1 as a Trunk port, allowing all VLANs to pass.
[DeviceB] interface GigabitEthernet 1/0/1
[DeviceB-GigabitEthernet1/0/1] port link-type trunk
[DeviceB-GigabitEthernet1/0/1] port trunk permit vlan all
# Enable GVRP on GigabitEthernet 1/0/1.
GE1/0/1
Device B