Console Port Login
Configuration
Common Configuration
Figure 6 Set port parameters terminal window
Turn on the switch. The user will be prompted to press the Enter key if the
■
switch successfully completes POST (power-on self test). The prompt (such as
<SW4800G>) appears after the user presses the Enter key.
You can then configure the switch or check the information about the switch
■
by executing commands. You can also acquire help by type the ? character.
Refer to the following chapters for information about the commands.
Table 5 lists the common configuration of console port login.
Table 5 Common configuration of console port login
Configuration
Console port
Baud rate
configuration
Check mode
Stop bits
Data bits
Console Port Login Configuration
Description
Optional
The default baud rate is 9,600 bps.
Optional
By default, the check mode of the console port is set to
"none", which means no check bit.
Optional
The default stop bits of a console port is 1.
Optional
The default data bits of a console port is 8.
33