Installing A Tapi Sound Card - Dell Precision WorkStation 530 User Manual

60 Adv a n c ed Fe a tu r es
Open the computer
3
Install the TAPI-compliant expansion
4
See the manufacturer's documentation for more information.
Connect the 4-pin TAPI cable to the TAPI system-board connector.
5
To locate the TAPI connector on the system board, see
Components" or the interior service label.
Connect the 4-pin TAPI cable to the TAPI expansion-card connector.
6
To locate the TAPI connector on the expansion card, see the
manufacturer's documentation.
Close the computer
7
Stand the computer upright.
8
Reconnect the computer and devices to their electrical outlets, and
9
turn them on.
NOTE:
If enabled, the
message to be displayed at the next system start-up:
ALERT! Cover was previously removed.
Install the appropriate TSP for the TAPI device.
10
See the manufacturer's documentation and your Windows
documentation for more information.

Installing a TAPI Sound Card

You can install a TAPI-compliant sound card that has a standard TAPI
connector. For example, you can connect your modem to the TAPI sound
card connector and then use the audio capabilities as a speakerphone.
CAUTION: Before you perform this procedure, see
For You and Your
NOTICE:
Before disconnecting a device from the computer, wait 10 to 20
seconds after disconnecting the computer from its electrical outlet. Before
removing a component from the system board, verify that the standby power
light on the system board has turned off. To locate this light, see
Components" or the interior service label.
Turn off the computer and devices, disconnect them from their
1
electrical outlets, and wait 10 to 20 seconds.
cover.
card.
cover.
Chassis Intrusion
option will cause the following
Computer."
"System Board
"Safety First—
"System Board