Dell Precision WorkStation 530 User Manual page 196

S y s t e m L i g h t C o d e s ( c o n t i n u e d )
Power Light Hard Drive Light Cause
Solid yellow N/A
Blinking yellow Blank
Blinking yellow Solid green
Solid green and a N/A
beep code during
POST
Solid green power N/A
light and no beep
code and no video
during POST
Solid green power N/A
light and no beep
code but the
computer locks up
during POST
196 So lv ing Pr o ble m s
The Dell Diagnostics is running a
test, or a device on the system board
may be faulty or incorrectly installed.
There is a power supply or system
board failure.
There is a system board failure.
A problem was detected while the
BIOS was executing.
The monitor or the graphics card may
be faulty or incorrectly installed.
An integrated system board device
may be faulty.
Corrective Action
If the Dell Diagnostics is running,
allow the testing to complete.
Check the diagnostic lights
the specific problem is identified.
Also, see "System Board Problems."
If the computer does not boot,
contact Dell for technical assistance.
Check the diagnostic lights
the specific problem is identified.
Also, see "Power Problems" and
"System Board Problems."
Check the diagnostic lights
the specific problem is identified.
Also, see "System Board Problems."
See "System Beep Codes" for
instructions on diagnosing the beep
code. Also, check the diagnostic lights
to see if the specific problem is
identified.
Check the diagnostic lights
the specific problem is identified.
Also, see "Video Problems."
Check the diagnostic lights
the specific problem is identified. If
the problem is not identified,
Dell for technical assistance.
to see if
to see if
to see if
to see if
to see if
contact