Dell Precision WorkStation 530 User Manual page 79

If necessary, remove memory modules
5
sockets in which you plan to install upgrade modules.
If you have the optional memory riser boards installed and you plan to
6
install upgrade modules on the riser boards,
Install the upgrade modules
7
NOTE: See "Computer Memory Installation
NOTE: Without the optional memory riser boards installed, the computer
supports a maximum of 64 memory devices on all installed RIMMs. With
the memory riser boards installed, the computer supports up to 128
memory devices (64 devices on each riser board). See
Label" for the location of the label on the RIMM that identifies the
number of memory devices it contains. You can also determine the number
of memory devices installed through the System Memory option in
setup.
If you removed the memory riser boards,
8
Close the computer
9
Stand the computer upright.
10
Reconnect the computer and devices to their electrical outlets, and
11
turn them on.
NOTE:
If enabled, the
message to be displayed at the next system start-up:
ALERT! Cover was previously removed.
The computer detects that the new memory does not match the
existing system configuration information and generates the following
message:
The amount of system memory has changed.
Strike the F1 key to continue, F2 to run the setup
utility
Enter system setup, and check the value for System Memory. The
12
computer should have already changed the value of System Memory
to reflect the newly installed memory. If the new total is correct, skip to
step 14.
If the memory total is incorrect, repeat
13
the installed modules and riser boards to ensure that they are seated
properly in their sockets. Then repeat
that occupy system board
remove the riser
in system board or riser board sockets.
Guidelines."
install the riser
cover.
Chassis Intrusion
option will cause the following
step 1
step 9 through
boards.
"Memory Module
system
boards.
through step 3. Check
step 12.
Re movi ng and Inst alli ng Part s
79