NEC NEAX 2000IVS2 Installation Manual page 401

Switch Settings
SWITCH
NAME
SW0 (DIP SW)
2 1
ON
JP1A (Jumper pin)
NOTE
JP1B (Jumper pin)
NOTE
OPSD
(Jumper pin)
OPRS
(Jumper pin)
OPER
(Jumper pin)
The figure in the SWITCH NAME column and the position in
column indicate the standard setting of the switch. When the switch is not set as shown by the
figure and , the setting of the switch varies with the system concerned.
NOTE: The JP1A and JP1B must be set to the same position each other.
2
NEAX2000 IVS Installation Procedure Manual
ND-70928 (E), Issue 1.0
CHAPTER 3 LAMP INDICATIONS AND SWITCH SETTINGS
SWITCH SETTING
NUMBER POSITION
1
OFF
2
OFF
Right
Left
Right
Left
Right
Left
Right
Left
Right
Left
FUNCTION
Always set to OFF
Not used
TXC(2) signal is sent out.
TXC(2) signal is inputted.
TXC(2) signal is sent out.
TXC(2) signal is inputted.
Set the function of extending dis-
tance for TXD signal.
Cancel the function of extending
distance for TXD signal.
Set the function of extending dis-
tance for RTS signal.
Cancel the function of extending
distance for RTS signal.
Set the function of extending dis-
tance for DTR signal.
Cancel the function of extending
distance for DTR signal.
in the SETTING POSITION
PN-M03 (M03)
CHECK
Page 375