CHAPTER 3 LAMP INDICATIONS AND SWITCH SETTINGS
PZ-M537 (EXPMEM)
Mounting PZ-M537 Card
When mounting the EXPMEM card on the AP00/MP card, do the following procedure.
STEP 1: Take off three screws from the rear side of EXPMEM support.
NOTE:
Supports and screws are attached to the EXPMEM card.
STEP 2: Connect the CONNR connector on the EXPMEM card and the CONN connector on the
AP00/MP card.
STEP 3: Secure the EXPMEM card to the AP00/MP card with three screws which taken by
STEP 1.
WHEN MOUNTING EXPMEM CARD
ON THE AP00 CARD
CONNR CONNECTOR
CONN CONNECTOR
Page 316
SUPPORT
EXPMEM CARD
EXPMEM CARD
AP00 CARD
WHEN MOUNTING EXPMEM CARD
ON THE MP CARD
CONNR CONNECTOR
MP CARD
NEAX2000 IVS
EXPMEM CARD
CONN CONNECTOR
2
Installation Procedure Manual
ND-70928 (E), Issue 1.0