NEC NEAX 2000IVS2 Installation Manual page 367

LAMP
COLOR
NAME
B00 Red
Switch Settings
SWITCH NAME
DL0
(Rotary SW)
0
NOTE
DL1
(Rotary SW)
0
NOTE
The figure in the SWITCH NAME column and the position in
column indicate the standard setting of the switch. When the switch is not set as shown by the
figure and , the setting of the switch varies with the system concerned.
NOTE: Set the groove on the switch to the desired position.
2
NEAX2000 IVS Installation Procedure Manual
ND-70928 (E), Issue 1.0
CHAPTER 3 LAMP INDICATIONS AND SWITCH SETTINGS
B channel status
ON
OFF
Flash (60 IPM) : ZT is not connected to the No. 0 circuit.
SWITCH SETTING
NUMBER POSITION
0
0-F
1-F
0
0-F
1-F
FUNCTION
: B0 channel of the No. 0 circuit is in use.
: B0 channel of the No. 0 circuit is idle.
ZT is in make-busy status.
FUNCTION
For normal operation
Not used
For normal operation
Not used
in the SETTING POSITION
PN-2CSIA (CSI)
CHECK
Page 341