NEC NEAX 2000IVS2 Installation Manual page 317

Lamp Indications
LAMP
COLOR
NAME
RUN Green
BUSY Red
SUBOPE3 Green
SUBOPE2 Green
SUBOPE1 Green
SUBOPE0 Green
L3 –
L2 –
L1 Green
IP-TX Green
IP-RX Green
IP-100M Green
IP-LINK Green
IP-COL Green
IP-LYR Green
2
NEAX2000 IVS Installation Procedure Manual
ND-70928 (E), Issue 1.0
CHAPTER 3 LAMP INDICATIONS AND SWITCH SETTINGS
Flashes at 120 IPM while this card is operating normally.
When even 1-line ON: Even one line is busy
When even 1-line OFF: All lines are idle
Remains lit when Card No.3 of PN-4VCTH is operating.
Remains lit when Card No.2 of PN-4VCTH is operating.
Remains lit when Card No.1 of PN-4VCTH is operating.
Remains lit when Card No.0 of PN-4VCTH is operating.
Not used
Not used
Remains lit when a loop-back test is in progress.
Remains lit when sending IP data.
Remains lit when receiving IP data.
ON: Ethernet is operating with 100 Mbps.
OFF: Ethernet is operating with 10 Mbps.
ON: Being connected to IP network (Link established).
OFF: Disconnected to IP network (No link established).
Remains lit when detecting IP data collision.
Remains lit when IP network is ready to use.
FUNCTION
PN-IPTA (IPT)
Page 291