Mounting Conditions Of Circuit Card; Circuit Card Mounting Slots; Figure 1-7 Circuit Card Mounting Slots - NEC NEAX 2000IVS2 Installation Manual

MOUNTING CONDITIONS OF CIRCUIT CARD

This section explains the conditions for mounting circuit cards used in the system.

Circuit Card Mounting Slots

The figure below shows circuit card mounting slots allocated in the PIM based on circuit card
type.
AC/DC
PWR
DC/DC
PWR
LT00-LT11 : Line/Trunk card mounting slots
AP00-AP11 : Application Processor card
mounting slots
MP : PN-CP14 mounting slot
FP : PN-CP15 mounting slots
*1 PZ-VM00-M card is to be mounted in LT00 slot to use VM slot.
*2 Either line/trunk cards or application processor cards can be mounted in LT00/AP00-
LT10/AP10 slots.
*3 Either PN-CP15 or a line/trunk card or an application processor card is to be mounted in
LT11/AP11/FP11 slot according to the system configuration.
*4 PN-CP14 or PN-CP15 card is to be mounted in MP12/FP12 slot according to the system
configuration.
*5 PZ-8PFTB card is to be mounted in PFT slot.
2
NEAX2000 IVS Installation Procedure Manual
ND-70928 (E), Issue 1.0

Figure 1-7 Circuit Card Mounting Slots

*
1
LTC1
LTC0
CHAPTER 1 GENERAL INFORMATION
*
2
LTC2
BWB
FRONT
VM : PZ-VM00-M mounting slot
PFT : PZ-8PFTB mounting slot
AC/DC PWR : PZ-PW121 mounting slot
DC/DC PWR : PZ-PW122 mounting slot
Mounting Conditions of Circuit Card
* 3 * 4 * 5
LTC3
Page 29