Table of Contents
Advertisement
Highpoint HPT372 Driver Installation
Highpoint HPT 372 Driver Installation
You can use your HPT372 as
1.
Normal IDE function.
2.
RAID function.
To use IDE3 and IDE4 as normal IDE, please do the following steps
1. Enable on-board IDE RAID in the bios.
2. Install the HP372 driver, see driver installation instruction below.
To use IDE3 and IDE4 as RAID controller, see Appendix A (page 92,
getting started section) for installation procedure.
To boot from the HPT372 controller, (IDE 3 or IDE 4)
1.
Go to the BIOS setup and set the First Boot device to SCSI.
2. Set the "RAID/ATA & SCSI boot order" to "RAID/ATA,SCSI".
SY-P4-645DX DRAGON Ultra
Chapter 7
85
Advertisement
Table of Contents
