Table of Contents
Advertisement
7. Select
3. Start Creation
8. Pay attention to the warning message, and press
creation.
Note:
1. If you have selected
the popup sub-interface after the operation of
you should directly go to
Start Creation
2. If user is creating RAID 0+1, then user must select four single
disks. All data on these disks will be destroyed after creation
of RAID 0+1.
3. Different warning messages appear according to different
RAID levels.
II. Delete RAID
The following steps shall be taken to delete RAID.
1.
In the menu zone, select
confirm this operation and go to next.
2.
In the validated channel status, use the arrow key to select
the disk array to be deleted and press
3.
Press
Y
the disk array?
III. Rebuild Mirror Array
The following steps shall be taken to rebuild the mirror array.
1.
In the menu, select
confirm.
2.
In the menu, select
Enter
to confirm.
3.
In the validated channel status, select the source disk of the
mirror array and then press Enter.
4.
In the menu, select
Enter
to confirm.
Striping (RAID 0) for Performance
Process. The default strip size is 64K.
when warned
Are you sure you want to remove
3. Rebuild Mirror
1. Select Source Disk: None
2. Select Target Disk: None
Process.
3. Strip Size 64K
2. Delete
RAID, press
Enter
Array, press
95
Y
to finish
1. Array
Mode,
and then select
Enter
to confirm.
Enter
and press
and press
in
4.
to
to
Advertisement
Table of Contents
