Hardware Installation
3. Cooling Fan Installation
(1) CPU Cooling Fan (CPUFAN1,CPUFAN2)
After you have seated the CPU properly on the processor, attach the 3-pin
fan cable to the CPUFAN connector on the motherboard. The fan will stop
when the system enters into Suspend Mode. (Suspend mode can be enabled
from the BIOS Setup Utility, [POWER MANAGEMENT] menu.)
To avoid any damage to the system, install according to the following pin
assignment:
CPU Cooling Fan
(CPUFAN1,CPUFAN2)
CPUFAN Pin Assignment
CPUFAN1/CPUFAN2
1
GND
12V
SY-P4-645DX DRAGON Ultra
2
3
SENSOR
26