Table of Contents
Advertisement
To be able to use the RAID function, please do the
following:
1. Connect the 2 Hard disk on IDE3/4
2. Enable the RAID function in the BIOS
3. Create a Disk Array. For create instructions see below.
4. Install HPT 372 driver; check chapter 7 for driver installation
procedure.
Note:
You can disable the HPT372 controller in the BIOS setup.
To boot from the HPT372 controller, (IDE 3 or IDE 4) go to the
BIOS setup and set the First Boot device to SCSI.
When setting up the RAID 0 or RAID 1, please use the IDE 3
master and IDE4 master. We do not recommend configuring the
RAID array on the same IDE.
You can create a disk array using:
1.
HPT372 BIOS Utility Configuration
Need to use this utility if you plan to install an operating
system on IDE3/4
2.
Highpoint ATA RAID Management software
Recommend using this software if you already have an
existing operating system in IDE1/2
HPT372 BIOS Utility Configuration
Enter into BIOS Configuration Utility
When the following information is displayed on screen during the
system start-up, press
utility.
Create a Disk Array
ctrl+H
key to enter into BIOS configuration
93
Advertisement
Table of Contents
