Ipl Network Menu; Ipl Rfid Menu; Ipl Test/Service Menu - Intermec PX4i User Manual

IPL Network Menu

IPL RFID Menu

IPL Test/Service Menu

PX4i and PX6i High Performance Printer User's Manual
SETUP:
NETWORK
NETWORK: NETWORK:
IP SELECTION IP ADDRESS
IP SELECTION: IP ADDRESS:
DHCP+BOOTP 0.0.0.0
PARITY:
MANUAL
PARITY:
DHCP
PARITY:
BOOTP
NETWORK: NETWORK:
NAMESERVER NAMESERVER6
NAMESERVER: NAMESERVER6:
0.0.0.0 00::0
SETUP:
Only displayed if an RFID module is installed.
RFID
RFID: RFID:
MODE TAGREAD
MODE: TAGREAD:
ENABLE
MODE:
DISABLE
Read-only
SETUP:
TEST/SERVICE
TEST/SERVICE:
TESTPRINT
TESTPRINT: TESTPRINT:
CONFIG TEST LABELS
CONFIG: TEST LABELS:
SW PITCH
CONFIG:
TEST LABELS:
HW
CONFIG: PRINT QUALITY
NETWORK
TEST/SERVICE: TEST/SERVICE:
DATA DUMP MEMORY RESET
DATA DUMP: MEMORY RESET:
NO
ALL
DATA DUMP:
MEMORY RESET:
YES
CONFIGURATION
Appendix C — Fingerprint and IPL Setup Menus
NETWORK: NETWORK:
NETMASK DEFAULT ROUTER
NETMASK: DEFAULT ROUTER:
0.0.0.0 0.0.0.0
NETWORK: NETWORK:
DHCP RESPONSE MAC ADDRESS
DHCP RESPONSE: MAC ADDRESS:
BROADCAST nnnnnnnnnnnn
DHCP RESPONSE:
UNICAST
Read_only
RFID: RFID:
TAGADJUST RETRIES
TAGADJUST: RETRIES:
+0 1
TESTPRINT: TESTPRINT:
FORMAT PAGE
FORMAT: PAGE:
ALL ALL
ALL: ALL:
PRINT FORMATS PRINT PAGES
TEST/SERVICE: TEST/SERVICE:
LSS TEST CMD LANGUAGE
LSS TEST: CMD LANGUAGE:
LSS AUTO IPL
CMD LANGUAGE:
ZSim
CMD LANGUAGE:
DSim
CMD LANGUAGE:
LSS AUTO:
Fingerprint
CMD LANGUAGE:
Direct Protocol
NETWORK: NETWORK:
IPV6 SELECTION IPV6 ADDRESS
IPV6 SELECTION: IPV6 ADDRESS:
AUTO 0000::000:0000:0
IPV6 SELECTION:
AUTO+DHCP
IPV6 SELECTION:
DHCP
IPV6 SELECTION:
MANUAL
NETWORK:
NETWORK TYPE
NETWORK TYPE:
Ethernet
NETWORK TYPE:
Wireless 802.11
RFID: RFID:
VOIDTEXT FIELDSTRENGTH
VOIDTEXT: FIELDSTRENGTH:
VOID 100
Read-only
TESTPRINT: TESTPRINT:
UDC FONT
UDC: FONT:
ALL ALL
ALL: ALL:
PRINT UDCs PRINT UDFs
PRINT DEFS:
Only displayed if a paper
LTS
LTS:
LTS:
LTS TEST
LTS ADJUST
REMOVE LABEL AND
REMOVE LABEL
PRESS ENTER ENTER TO STOP
171