Intermec PX4i User Manual page 98

Chapter 3 — Configuring the Printer
84
3 Select the Notification method.
4 Click Submit Settings.
Use the following table to understand the Alert Settings.
Understanding the Alert Settings
Setting
Label Not Taken
(Fingerprint only)
Cutter Error
Head Lifted
Out of Ribbon
Pause Mode
Setup Mode
Error Condition
(Fingerprint only)
Application Break
(Fingerprint only)
Print Job Complete
(Fingerprint only)
Odometer Count 1 The amount of media printed has reached a preset
Notification
Method
Description
Sent when the printed label is not taken from the
printer. This setting applies to label and ticket media
and requires an optional label taken sensor.
There was an error related to the label cutter.
A printer job was sent to the printer while the
printhead was lifted.
You have thermal transfer ribbon selected and the
printer is out of ribbon.
The printer is in Pause mode.
The printer is in Setup mode.
An error has occurred in the Fingerprint application.
The error does not have to be critical to the print job for
the printer to send this alert.
A running Fingerprint application has been
interrupted manually or because of an error.
The print job has been successfully completed.
amount, measured in meters or in number of labels.
The Delay repeat setting represents how often the alert
message will be sent when the preset value is reached.
The method used to send an alert message. You can
choose from mail, SNMP-trap, or both.
PX4i and PX6i High Performance Printer User's Manual