Adjusting The Label Taken Sensor - Intermec PX4i User Manual

Adjusting the Label Taken Sensor

PX4i and PX6i High Performance Printer User's Manual
Chapter 4 — Troubleshooting and Maintaining the Printer
To adjust the printhead pressure
1 Turn the adjustment knob clockwise for more pressure and a
darker printout (+) or counter-clockwise for less pressure (-) and a
lighter printout.
2 Print test labels to check the print quality. For help, see
a Test Label" on page
To return the printhead pressure to the factory default setting
• Tighten the knob (+) as much as you can, and then loosen it (-)
four full turns.
If you are using the optional label taken sensor (LTS), you may need
to adjust the sensitivity depending on ambient light conditions and
the reflective characteristics of the back side of the media.
To adjust the LTS
1 Press T to enter the Setup menu, and use the keypad to go to the
LTS menu:
• If you are running Fingerprint, go to SETUP > PRINT DEFS >
LTS.
• If you are running IPL, go to SETUP > TEST/SERVICE >
LTS.
52.
"Printing
125