Intermec PX4i User Manual page 104

Chapter 3 — Configuring the Printer
90
Use the following table to understand SNMP settings.
Understanding the SNMP Settings
Setting
Read Community
Read/Write
Community
Username
Authentication Key The authentication key for SNMPv3. The default value
Encryption Key
System Name
Authentication
Failure Trap
Trap Address
Settings
Description
Community with rights to read the SNMP MIBs.
Community with rights to read and write SNMP MIBs.
Username when using SNMPv3. The default value is
"initial".
is "auth_key".
The privacy key for SNMPv3. The default value is
"priv_key".
Administrative name for the SNMP node.
Defines if a trap is sent when an unauthorized SNMP
request tries to access the printer. Choose Enable to
send the trap.
Click Add to specify these trap address settings:
•
Trap Address: IP address of the receiver of SNMP
traps. You can specify up to four trap addresses.
•
Trap Port: The port where SNMP traps are sent.
The default port if 162.
•
Trap Community: Defines the community to
which SNMP traps will be sent.
•
Friendly Name: A user-defined text string that
identifies the trap.
•
Trap Enable Status: Defines whether the specified
trap is enabled.
PX4i and PX6i High Performance Printer User's Manual