Intermec PX4i User Manual page 124

Chapter 4 — Troubleshooting and Maintaining the Printer
Fingerprint Error Messages (continued)
Message Description
LSS too low This error can occur when you run a test feed
without any media installed, or if you have incorrect
media settings. Load the printer with media and
select the appropriate media type. For help, see
"Loading Media" on page
Testfeed not The printer did not perform a test feed before it
done printed out test labels. Performing a test feed
calibrates the sensor.
To perform a testfeed
Press the A button.
•
No RFID The optional RFID interface is not installed in the
support printer.
installed
No tag found No RFID tag has been found.
Pause Mode The print job is paused.
Entered
Setup Mode The printer is in Setup mode.
Entered
IP link error No network connection.
IP The printer is trying to acquire an IP address from
configuration the network. Wait for the printer to complete the
error task before taking any action.
Generic DP In Direct Protocol, you can enable error handling for
error specific errors using the ERROR statement. When
errors added to the built-in error handling occur, this
event is set. The text included in the SNMP trap is
the standard text corresponding to the error.
Press any key If an error occurs in the Fingerprint immediate
to continue mode, for example "out of paper" when the print key
is pressed, this event is set.
Application If an application is started but does not run, the
load error Intermec Ready-to-Work indicator blinks. For
example, if there is a syntax error in the loaded
program file.
RtW blink by This condition is set by the Fingerprint SYSHEALTH
application command. For more information, see the
Fingerprint Command Reference
110
8.
Intermec
Manual.
PX4i and PX6i High Performance Printer User's Manual
Ready-to-Work Error
Indicator Status Number
Blinking 1008
Blinking 1606
Blinking 1320
Blinking 1321
Blinking
Off
Blinking
Blinking
Blinking
Off
Blinking
Blinking