Intermec PX4i User Manual page 162

Appendix A — Specifications
148
Liner (b)
The backing paper must not extend more than a total of 1.6 mm
(0.06 in) outside the labels and should protrude equally on both side.
Recommended minimum transparency: 40% (DIN 53147).
Media Width Excluding Liner (c)
Printer Measurement
PX4i Maximum
Minimum
PX6i Maximum
Minimum
Label Length (d)
Measurement
Minimum without LTS 8 mm (0.32 in)
Minimum with LTS
Maximum
Note: Under ideal circumstances, a minimum label length of 4 mm
(0.16 in) could be used. It requires the sum of the label length (d) and
the label gap (e) to be larger than 7 mm (0.28 in), that batch printing is
used, and that no pull back of the media is performed. Intermec does
not guarantee that such short labels will work, but it is up to users to
test this in their unique application.
Label Gap (e)
Measurement Value
Maximum 25.0 mm (0.98 in)
Recommended 3.0 mm (0.12 in)
Minimum 1.2 mm (0.05 in)
The Label Stop Sensor (LSS) must be able to detect the extreme front
edges of the labels.
Value
118.4 mm (4.66 in)
23.8 mm (0.94 in)
168.4 mm (6.63 in)
74.4 mm (2.93 in)
Value
12 mm (0.47 in)
6,143 mm (241 in) Depends on SDRAM size.
PX4i and PX6i High Performance Printer User's Manual